05-01-2007 03:17 AM - edited 03-03-2019 04:46 PM
I have MGX8250 and recently i have inserted in VISM-8E1 card . Presently the VISM -8E1 card is in BOOT mode . I am not sure how do i burn a firmware into that . in MGX8850 setrev is the command . I have found in MGX8250 documentation in Cisco site and the command is commit sm <rev> . I have applied that but the command is not going thru . Can you please let me know the exact command .
I want to burn 002.001.000.000 image.
Regards
Arjun
05-07-2007 06:07 AM
For information on burning the image kindly refer to the following URL,
05-12-2007 07:32 PM
You have to first execute the PXM install command ...
"install sm
e.g. "install sm 1 vism_8t1e1_002.001.000.000.fw"
Then you have to execute the PXM newrev command ...
"newrev sm
e.g. "newrev sm 1 vism_8t1e1_002.001.000.000.fw"
Finally you have to execute the PXM commit command ...
"commit sm
e.g. "commit sm 1 vism_8t1e1_002.001.000.000.fw"
rgds
Joern
SwitchXchange
05-13-2007 11:13 PM
Hello Joerm ,
Thanks for the update . But the command didn't work as expected . Finally i got the
process and i am planing to apply .
The problem is MGX8250 is pretty old box and the commands diffres from MGX8850 chassis .
C:\cp vism_8t1e1_002.001.000.000.fw \FW\sm150.14.fw
install sm 14 002.001.000.000
Regards
Arjun
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide