05-01-2007 03:17 AM - edited 03-03-2019 04:46 PM
I have MGX8250 and recently i have inserted in VISM-8E1 card . Presently the VISM -8E1 card is in BOOT mode . I am not sure how do i burn a firmware into that . in MGX8850 setrev is the command . I have found in MGX8250 documentation in Cisco site and the command is commit sm <rev> . I have applied that but the command is not going thru . Can you please let me know the exact command .
I want to burn 002.001.000.000 image.
Regards
Arjun
05-07-2007 06:07 AM
For information on burning the image kindly refer to the following URL,
05-12-2007 07:32 PM
You have to first execute the PXM install command ...
"install sm
e.g. "install sm 1 vism_8t1e1_002.001.000.000.fw"
Then you have to execute the PXM newrev command ...
"newrev sm
e.g. "newrev sm 1 vism_8t1e1_002.001.000.000.fw"
Finally you have to execute the PXM commit command ...
"commit sm
e.g. "commit sm 1 vism_8t1e1_002.001.000.000.fw"
rgds
Joern
SwitchXchange
05-13-2007 11:13 PM
Hello Joerm ,
Thanks for the update . But the command didn't work as expected . Finally i got the
process and i am planing to apply .
The problem is MGX8250 is pretty old box and the commands diffres from MGX8850 chassis .
C:\cp vism_8t1e1_002.001.000.000.fw \FW\sm150.14.fw
install sm 14 002.001.000.000
Regards
Arjun
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: