Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
383
Views
0
Helpful
2
Replies

Changing IPCCx CODECs

m.dibben
Level 1
Level 1

‎05-01-2007 04:41 AM - edited ‎03-14-2019 12:48 AM

Hi All

I am having trouble with IPCC express codec negotiation, it always uses G729. I have tried everything I can think of to change this in Call Manager to G711. I can see that the codec used under system parameters is G729, does that mean that it will only use G729.

I have configured the CTI ports in a region that uses G711. Is there a way of changing this codec, a re-install is a possibility but I would like to know it is going to work first.

Any assistance will be greatly received

Regards

Martin

Labels:
0 Helpful
2 Replies 2

JimSJ
Level 4
Level 4

‎05-01-2007 05:38 AM

Martin,

IPCC Express will only work with one codec and it can only be selected at install time. If it indicates it is set to G.729, a reinstall would be required to use G.711. However, you can always use transcoders to translate between the two if you have hard requirements on one side or the other that are in conflict.

Hope this helps,

Jim

0 Helpful

m.dibben
Level 1
Level 1
In response to JimSJ

‎05-01-2007 06:02 AM

Many thanks Jim, I think I must have selected to install G729 accidentally then!

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents