Input errors on FastEthernet, 1300 bridge

Unanswered Question

I'm getting a lot of input/crc errors on the eth int for a 1300 bridge. I originally suspected a bad power injector/eth port, replaced it and I'm still receiving errors. This bridge never posed a problem before, so I doubt it is a bad cable run. There were also a lot of interface resets, line protocol up/downs before the inj replacement.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
sethgarnar Tue, 05/01/2007 - 07:49

Interface resets and crc errors are almost always physical line related issues. I'd replace the cat5 and maybe reterminate the coax connections.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode