Changing native VLAN

Unanswered Question
May 1st, 2007
User Badges:

Good afternoon,


I have two Catalyst 6506 switches running IOS version 12.2(18)SXF6 and have a trunk link between the two. One side is set to switchport and the other is a layer 3 interface with subinterfaces. I need to change the native vlan on the switchport side and need to know if I need to make any configuration changes on the layer 3 interface side? Also if and when I do change the native vlan on the switchport side will there be any major interruption of service to the trunk?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Amit Singh Tue, 05/01/2007 - 09:46
User Badges:
  • Cisco Employee,

To change the native vlan on the trunkport do the following:


conf t

interface gig x/y

switchport trunk native vlan X <- native vlan number


There will not be a major disruption of the service as such, you will get some error messages for " Native vlan mismatch " on the trunk ports untill both the sides are configured for the same vlan.


HTH,

-amit singh

Actions

This Discussion