jreekers Tue, 05/01/2007 - 14:10
User Badges:
  • Cisco Employee,

A "show ver" should give you that (as long as it's running IOS).

mgracias Wed, 05/02/2007 - 15:17
User Badges:

How can i login into the AP(LWAP).It is not allowing me to telnet.Is there any way i can login into the AP.

leon.mflai Thu, 05/03/2007 - 08:39
User Badges:

For LWAPP AP 1230 and 1240 version, you can login to the AP via Console cable.

zhenningx Mon, 05/14/2007 - 06:55
User Badges:
  • Bronze, 100 points or more

In WCS, select the AP, and select "UP Time" in the "select a report" list.


Zhenning

ericgarnel Tue, 05/15/2007 - 10:03
User Badges:
  • Gold, 750 points or more

For the lwapp based APs (10x0) series, you can run the controller in L3 mode and have the APs pull ip addresses. As of 4.1.x, they are now pingable.


You can then change them from dhcp to static ips and then use a monitoring tool such as Cacti or nagios to monitor them.


With a mesh, it is theoretically possible to monitor ping latency to each mesh AP and then that as a guide to determine if the pole top APs have switched to a root that more hops away: assuming that more hops would result in increased latency. Many NMS systems can kick back uptime based on icmp results

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode