cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
268
Views
0
Helpful
1
Replies

address translation on router

cfajardo1_2
Level 1
Level 1

How to achieve the following. What are the commands i could use to achieve this?

scenario;

PCin-----(e1)router(e0)--------PCout

requuirement;

1. any traffic that comes from PCin directed to the router should be translated to the ip address of e0.

2.any traffic that is coming from PCout going to eo should be translated to ip address of PCin.

Thanks a lot.

1 Reply 1

mohammedmahmoud
Level 11
Level 11

Hi,

You can do both NAT inside and NAT outside, having e1 as the inside interface and e0 as the outside interface, its something as in this document:

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_configuration_example09186a0080093f30.shtml

Please don't hesitate for further questions.

HTH, please rate if it does help,

Mohammed Mahmoud.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: