4006 - Sytem conversion CatOS to IOS

Answered Question
May 2nd, 2007
User Badges:

Hello,

I need to upgrade a Catalyst 4006 from CatOS to IOS.

I have some doubt.

Is it possible? Wich are the rquirements? Wich is the procedure? Any issues?

Thanks in advance

Enrico

Correct Answer by mohammedmahmoud about 9 years 11 months ago


Hi,


The Catalyst 4500/4000 Series Supervisor II-Plus, III, IV and V runs Cisco IOS? software only, and does not run Catalyst OS software. While Supervisor 1 and 2 runs only CatOS and can't be converted.



HTH, please rate if it does help,

Mohammed Mahmoud.

Correct Answer by ankbhasi about 9 years 11 months ago

Hi Enrico,


You cannot convert from CATOS to IOS on Cat4006.


SUP 1 & Sup 2 on Cat4000 switch only supports CATOS and NOT IOS.


HTH


Ankur


*PLs rate all helpfull post


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
ankbhasi Wed, 05/02/2007 - 06:00
User Badges:
  • Cisco Employee,

Hi Enrico,


You cannot convert from CATOS to IOS on Cat4006.


SUP 1 & Sup 2 on Cat4000 switch only supports CATOS and NOT IOS.


HTH


Ankur


*PLs rate all helpfull post


Correct Answer
mohammedmahmoud Wed, 05/02/2007 - 06:12
User Badges:
  • Green, 3000 points or more


Hi,


The Catalyst 4500/4000 Series Supervisor II-Plus, III, IV and V runs Cisco IOS? software only, and does not run Catalyst OS software. While Supervisor 1 and 2 runs only CatOS and can't be converted.



HTH, please rate if it does help,

Mohammed Mahmoud.

Actions

This Discussion