05-02-2007 05:56 AM - edited 03-05-2019 03:48 PM
Hello,
I need to upgrade a Catalyst 4006 from CatOS to IOS.
I have some doubt.
Is it possible? Wich are the rquirements? Wich is the procedure? Any issues?
Thanks in advance
Enrico
Solved! Go to Solution.
05-02-2007 06:00 AM
Hi Enrico,
You cannot convert from CATOS to IOS on Cat4006.
SUP 1 & Sup 2 on Cat4000 switch only supports CATOS and NOT IOS.
HTH
Ankur
*PLs rate all helpfull post
05-02-2007 06:12 AM
Hi,
The Catalyst 4500/4000 Series Supervisor II-Plus, III, IV and V runs Cisco IOS? software only, and does not run Catalyst OS software. While Supervisor 1 and 2 runs only CatOS and can't be converted.
HTH, please rate if it does help,
Mohammed Mahmoud.
05-02-2007 06:00 AM
Hi Enrico,
You cannot convert from CATOS to IOS on Cat4006.
SUP 1 & Sup 2 on Cat4000 switch only supports CATOS and NOT IOS.
HTH
Ankur
*PLs rate all helpfull post
05-02-2007 06:12 AM
Hi,
The Catalyst 4500/4000 Series Supervisor II-Plus, III, IV and V runs Cisco IOS? software only, and does not run Catalyst OS software. While Supervisor 1 and 2 runs only CatOS and can't be converted.
HTH, please rate if it does help,
Mohammed Mahmoud.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: