Hello,

I am trying to create a route-map to have a specific VLAN in our 6509-Rter to default route and use

outbound internet through MCI ISP. Internal routing is OSPF, the 6509Rter gateway of last resort is

out through ISPQwest, we have a 100 MB wan link between the 6509-Rter, on the 6506Rter I made its default

route to go out the ISPMCI. On the PIX I have created the nessesary access-list and PAT for outbound connections.

The reason I would want to route the especific VLAN on the 6509Rter is because our T1 to the internet from the

Qwest side has been bursting so internet is very slow, on the MCI side we have unlimited internet bandwidth

and until we upgrade the internet T1 I need to accomodate critical outbound traffic for some systems retreaving

time sensitive market data information from the internet.

Could someone give me some examples .

This is the tolopogy :

Internal Routing is OSPF and default route is out through Qwest.

On the 6506Rter its default route is statically given to go out the MCI ISP

Phisical

ISPQWEST<-->PIX515E<-FE->6509Rter<--100MB-WAN->6506router<-FE->2811Rter<-FE->PIX515e-->ISPMCI

Logical

6509Rter-10.10.0.2><10.10.0.1-6506Rter-192.168.12.1><192.168.12.2-2811Rter><192.168.2.1><To-PIX515e

On the 6509Rter I have created the route map for a test subnet but it did not work, what did I missed?

6509Rter

interface vlan22

ip address 10.168.100.2

ip policy route-map cadlab-traffic

access-list 100 permit ip host 10.168.100.2

route-map cadlab-traffic permit 10

match ip address 1

set ip default next-hop 10.10.0.1

Thanks

Jorge