05-03-2007 03:58 AM - edited 03-03-2019 04:48 PM
Hi everybody,
I have a Cisco 7507 chassis with two RSP4+ processors running 12.3(18) image. Is it possible to swap active/slave processor issuing a CLI command? Otherwise how can I force this swap?
Regards
Stefano
05-03-2007 04:25 AM
Hi,
To switch control of a router from the active to the standby Route Switch Processor (RSP), use the redundancy force-switchover command in privileged EXEC mode.
redundancy force-switchover
Regards
Bjornarsb
05-03-2007 04:30 AM
Hi,
Router# redundancy force-switchover
Forces a switchover to the standby RSP.
NOTE: Both the active and standby RSPs must have a high availability Cisco IOS image installed and must be configured for RPR redundancy mode before the redundancy force-switchover command can be used.
HTH, please rate if it does help,
Mohammed Mahmoud.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: