What does.....

Unanswered Question
May 3rd, 2007

no atm ilmi-keepalive


This is on the atm interface of the ADSL Router. Its a 877W ADSL Router.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
royalblues Thu, 05/03/2007 - 05:15

From the command reference

atm ilmi-keepalive

To enable Interim Local Management Interface (ILMI) keepalives, use the atm ilmi-keepalive command in interface configuration mode. To disable ILMI keepalives, use the no form of this command.

atm ilmi-keepalive [seconds]

no atm ilmi-keepalive [seconds]

Syntax Description


(Optional) Number of seconds between keepalives. Values less than 3 seconds are rounded up to 3 seconds, and there is no upper limit.

Defaults 3 seconds

Command Modes

Interface configuration

Command History

Release Modification 11.0 This command was introduced.


The following example enables ILMI keepalives for the ATM interface 1/0:

interface atm 1/0

atm address-registration

atm ilmi-keepalive

HTH, rate if it does


bjornarsb Thu, 05/03/2007 - 05:19


When you configure VC management, you enable the router to detect VC connections and disconnections automatically. This notifies protocols to reroute packets immediately, preventing protocols from waiting for unpredictable and relatively long timeout periods. You may use Integrated Local Management Interface (ILMI) or operation, administration, and maintenance (OAM) or both for managing your PVCs, and OAM for managing your SVCs.




This Discussion