AP1010 doesn't connect to the 4100 WLC

Unanswered Question
May 3rd, 2007

Hello, I have a WLC using Firmware and i have also 2 AP1010-E-K9 LAP. Both AP doesn't startup in the right way. The LEDs get red, then green, then off for a longer while with a lot of network traffic, then red again. After that the same procedure starts up again. What can i do to get them working again?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode