cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
962
Views
0
Helpful
2
Replies

UdpJitter(codec) configuration using SNMP

masur_fox_spr
Level 1
Level 1

Hi,

Who can told me order of setting objects for UdpJitter(codec)operation?

For example following is order of setting objects for UdpJitter without codec:

rttMonCtrlAdminRttType.<index> -Integer 9

rttMonEchoAdminProtocol.<index> -Integer 27

rttMonEchoAdminTargetAddress.<index> -OctetString "05 00 00 02"

rttMonEchoAdminTargetPort.<index> -Integer 8000

rttMonEchoAdminInterval.<index> -Integer 20

rttMonEchoAdminNumPackets.<index> -Integer 100

rttMonCtrlAdminStatus.<index> -Integer 4

rttMonScheduleAdminRttStartTime.<index> -TimeTicks 1

Thanks ahead

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

You can insert the rttMonEchoAdminCodecType just before rttMonCtrlAdminStatus. However, you cannot specify rttMonEchoAdminPktDataRequestSize, rttMonEchoAdminInterval, or rttMonEchoAdminPackets if you specify a codec. See the CISCO-RTTMON-MIB for more details.

View solution in original post

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

You can insert the rttMonEchoAdminCodecType just before rttMonCtrlAdminStatus. However, you cannot specify rttMonEchoAdminPktDataRequestSize, rttMonEchoAdminInterval, or rttMonEchoAdminPackets if you specify a codec. See the CISCO-RTTMON-MIB for more details.

Thanks very much!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco