Cisco CME to SIP Proxy

Unanswered Question

Hello, I have two 7940 phones running SCCP with CME 3.3 on a 2611XM Router. I'm trying to use my SIP phone number for the primary phone number using the SIP-UA in CME. So far the SIP-UA is registered and I can dial the sip number and both phones ring, but my problem is that I cant dial out from any phone. I have tried a few different dial-peers but i still cant dial out. Any help would be greatly appreciated. Thankyou. Chris.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Fri, 05/04/2007 - 00:45

Hi Chris,

to which SIP proxy are you connecting ? Most likely they want authentication, have you configured that under sip-ua ?

Please enable "term mon" and "debug ccsip message" for a failed call and that will tell you what is going wrong.

Hope this helps, please rate post if it does!


This Discussion