Configuring lines 1 60 on Cisco 2821

Unanswered Question
May 3rd, 2007
User Badges:

Hi all,


I'd like to know what is necessary to configure the parameter line 1 60 in a Cisco 2821 router with a two E1's direct connected in a interfaca VWIC2-MFT-E1 and two PVDM's modules installed.


When I try to enter the line "router(config)#line 1 60" the ios returns an error message that there are no physical hardware to support "line 2". I just can enter line 1.


Which is necessary to do this?


My best Regards,

Adriano

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
irisrios Wed, 05/09/2007 - 10:17
User Badges:
  • Silver, 250 points or more

try to do a show of the interface using the following example and see the output.

#sh voice po 1/1


Actions

This Discussion