cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
982
Views
0
Helpful
1
Replies

Routing problem in EIGRP

network_a
Level 1
Level 1

Can any one describe below mentioned logs from debug eigrp notofication

VCC_NOI_RTR01#

004441: *May 4 14:27:43.123 UTC: IP-EIGRP(Default-IP-Routing-Table:0): Callback: redist connected (config change) GigabitEthernet0/0

004442: *May 4 14:27:43.123 UTC: IP-EIGRP(Default-IP-Routing-Table:100): Callback: route_adjust GigabitEthernet0/0

004443: *May 4 14:27:43.123 UTC: IP-EIGRP(Default-IP-Routing-Table:0): Callback: redist connected (config change) GigabitEthernet0/1

004444: *May 4 14:27:43.123 UTC: IP-EIGRP(Default-IP-Routing-Table:100): Callback: route_adjust GigabitEthernet0/1

004445: *May 4 14:27:43.123 UTC: IP-EIGRP(Default-IP-Routing-Table:100): Callback: reload_iptable

004446: *May 4 14:27:44.127 UTC: IP-EIGRP(Default-IP-Routing-Table:100): iptable_redistribute intoeigrp

004447: *May 4 14:27:48.123 UTC: IP-EIGRP(Default-IP-Routing-Table:0): Callback: redist connected (config change) GigabitEthernet0/1

004448: *May 4 14:27:48.123 UTC: IP-EIGRP(Default-IP-Routing-Table:100): Callback: lostroute 54.19.X.0/23

note:- The route for 54.19.X.0 is not reaciving on the router

1 Reply 1

royalblues
Level 10
Level 10

The logs show that the routes are being learnt/ removed because of a config change

callbackup_routes means at some point, EIGRP attempted to install routes to the destinations and failed, most commonly because of the existence of a route with a better administrative distance.

When this occurs, EIGRP registers its route as a backup route. When the better route disappears from the routing table, EIGRP is called back through callbackup_routes so that it can attempt to reinstall the routes that it is holding in the topology table.

HTH, rate if it does

Narayan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: