call fallback active problem

Unanswered Question
May 5th, 2007
User Badges:

PBXA-PRI-2851---IP-----2851-PRI--PBXB.

Calls between two PBX are fine with this setup. Then I tested the busyout monitor probe IP, which requires call fallback command, so taht when IP down PBX will re-route call to PSTN automatically. However as soon as I added call fallback active, call not working anymore. Debug voip ccapi inout shows H323call setup just does not receive on the other router at all. Has anybody seen this before?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Sun, 05/06/2007 - 05:01
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hello,


have you configured the parameters ?


call fallback threshold delay loss

call fallback threshold icpif


These have no default values so I guess unless configured properly the effect would be to block all calls.


Hope this helps, please rate post if it does!

Actions

This Discussion