Tunnel

devang_etcom · ‎05-05-2007

*Mar 1 01:16:28.419: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to up

*Mar 1 01:16:57.419: %TUN-5-RECURDOWN: Tunnel0 temporarily disabled due to recursive routing

*Mar 1 01:16:58.419: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to down

I have this message constantly prompting on my scree... it indicating the tunnel protocol is down... but the other end of the tunnel is remain UP/UP... so what is the cause of this side tunnel interface flapping from up to down and up...?

regards

Devang

devang_etcom · ‎05-05-2007

its resolved now...

Harold Ritter · ‎05-06-2007

The good old tunnel recursion problem ;-)

Harold Ritter
Sr Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México

royalblues · ‎05-06-2007

Devang

I used to face the same problem in our MPLS when the GRE tunnel address was getting redistributed.

What was the problem in your case

Narayan

devang_etcom · ‎05-06-2007

Narayan,

here is the link for you ...

http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094690.shtml

regards

Devang