05-05-2007 10:47 PM - edited 03-03-2019 04:51 PM
*Mar 1 01:16:28.419: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to up
*Mar 1 01:16:57.419: %TUN-5-RECURDOWN: Tunnel0 temporarily disabled due to recursive routing
*Mar 1 01:16:58.419: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to down
I have this message constantly prompting on my scree... it indicating the tunnel protocol is down... but the other end of the tunnel is remain UP/UP... so what is the cause of this side tunnel interface flapping from up to down and up...?
regards
Devang
05-05-2007 10:55 PM
its resolved now...
05-06-2007 07:20 AM
The good old tunnel recursion problem ;-)
05-06-2007 07:22 AM
Devang
I used to face the same problem in our MPLS when the GRE tunnel address was getting redistributed.
What was the problem in your case
Narayan
05-06-2007 11:37 AM
Narayan,
here is the link for you ...
http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094690.shtml
regards
Devang
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: