Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
317
Views
5
Helpful
4
Replies

Tunnel

devang_etcom
Level 7
Level 7

‎05-05-2007 10:47 PM - edited ‎03-03-2019 04:51 PM

*Mar 1 01:16:28.419: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to up

*Mar 1 01:16:57.419: %TUN-5-RECURDOWN: Tunnel0 temporarily disabled due to recursive routing

*Mar 1 01:16:58.419: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to down

I have this message constantly prompting on my scree... it indicating the tunnel protocol is down... but the other end of the tunnel is remain UP/UP... so what is the cause of this side tunnel interface flapping from up to down and up...?

regards

Devang

Labels:
0 Helpful
4 Replies 4

devang_etcom
Level 7
Level 7

‎05-05-2007 10:55 PM

its resolved now...

0 Helpful

Harold Ritter
Cisco Employee
Cisco Employee
In response to devang_etcom

‎05-06-2007 07:20 AM

The good old tunnel recursion problem ;-)

Harold Ritter
Sr Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México

royalblues
Level 10
Level 10
In response to devang_etcom

‎05-06-2007 07:22 AM

Devang

I used to face the same problem in our MPLS when the GRE tunnel address was getting redistributed.

What was the problem in your case

Narayan

0 Helpful

devang_etcom
Level 7
Level 7
In response to royalblues

‎05-06-2007 11:37 AM

Narayan,

here is the link for you ...

http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094690.shtml

regards

Devang

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card