I know enough to be dangerous. I downloaded the new Cisco SDM software package and installed it. Thought I was configuring my router. It did. And now I cannot get out. I played with it for a little while with no success. So I tried to go back to CRWS. That did not seem to work either. So, on the advice of a friend I removed all the new software and now I cannot access the router via the CRWS or SDM. I have to go thru the console port to configure. Like I said I do not have the smarts to configure it thru the console port to just run as a basic router/switch. Can anyone tell me how to get CRWS working again with the router? Since I cannot access it via IP I cannot use SDM. Or can someone post a basic router config to use while I attempt to get it working again. I have a VOIP service which uses an adapter to provide the voice. It used to go thru the router until I used SDM. Thanks in advance.