05-06-2007 09:03 PM - edited 03-05-2019 03:54 PM
I got two switches interconnected on ethernet ports and trunked useing dot1q. They keep changing status from protocol up to down not always the same interval either. Cant paste a config so ask me specific things to diagnose the issue please.
05-06-2007 09:19 PM
Hi
Check the cable,speed,duplex settings.
Thanks
Mahmood
05-07-2007 04:42 AM
Duplex and speeds are the same. Cable has been checked. Could it be a possible power issue. We are using generators to power the area we dont have an ups yet. I just want to make sure it couldn't be anything else.
05-07-2007 05:46 AM
Hi Friend,
If it is a power issue it will reload the whole switch and not one particular interface.
So can you check for some errors on the interface if you observe any? Also cehck if you see something in logs? Have you also configured errdisable recovery?
Regards,
Ankur
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: