micdenne Wed, 05/09/2007 - 09:45
User Badges:
  • Cisco Employee,

Hi Sanjoy2006.


This may depend on which IOS version you are running on your 1100 series access points. Here is a link to the configuration guides for the 1100. You can select the applicable software version and the section you would look for would be "configuring authentication types". Here is the link to the wireless configuration guide page:


http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_installation_and_configuration_guides_list.html


Another resource which might be helpful includes the AAA - Access Control Server - Configuration guidelines as well as some info about CLI configuration of the access points. This can be found here:


http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a0080545a29.shtml


Hope this helps

rochopra Fri, 08/03/2007 - 02:34
User Badges:
  • Cisco Employee,

Following link can give you information on configuration of EAP through GUI and CLI:


http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801bd035.shtml


Remember PEAP is not something which you setup on AP, AP has a default configuration to allow EAP protocol.

The settings related to protocol selection like PEAP, EAP-TLS etc needs to be done on Radius Server and Client machines.


Following link can give information on configuration of Radius server and client machines:

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00801df0e4.shtml


Hope this helps.


~Rohit



Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode