i get a error message while adding a line in Cisco ASA

Unanswered Question
May 6th, 2007


i get error message "ERROR: access-list has protocol or port" while adding a line nat (inside) 0 access-list zeronat0" can some one tell me what exactly the problem is.

Cisco ASA 5510 - asa704-k8.bin

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Anand Narayana Sun, 05/06/2007 - 23:22

what exactly it mean? this message i get in my standby ASA, where as in my main ASA i never get this message when adding, also in main ASA, when i type "write standby" all lines gets synced,except the one which i was trying.


This Discussion