05-07-2007 06:46 AM
Hi,
We have CCM 5.0,2811 voice gateway,1 4FXO and 1 g.shdsl card on it. 4 Telco lines are on 4FXO card.CCM is at the other side of g.shdsl line.Topology like that,
2811 ---------------- CCM
4fxo g.shdsl
When a call receives from FXO port, system is working normally without QoS. When we enable QoS traffic,traffic is going over wan link then return again.Because of that,delays and timeouts occuring.Router's config is at the attachment. Please Help!
Thank you
05-07-2007 03:45 PM
Check your H323 gateway config in CCM to be sure the Media Termination Point Required box is unchecked. Using MTP forces the call to terminate on the closest MTP resource which is likely at your CCM site.
Please rate helpful posts.
Dave
05-09-2007 10:09 PM
Hello,
I checked CCM configuration but MTP checkbox was unchecked. Im still looking for a solution.
Thanks for your help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: