05-07-2007 06:59 AM - edited 03-03-2019 04:52 PM
Hi All Manish this side,
I just want to know that can we achive load sharing and redundancy both, while using HSRP.
05-07-2007 07:06 AM
Hey Manish,
Yes you can achieve both using HSRP. To achieve load balancing you have to configure MHSRP.
http://www.cisco.com/warp/public/619/7.html
http://www.cisco.com/univercd/cc/td/doc/cisintwk/ics/cs009.htm
HTH
Ankur
*Pls rate all helpfull post
05-07-2007 07:25 AM
Thanks Ankur,
One more thing can we use ip address instead of preempt in this command "standby 1 preempt".
and which series of routers that we can configure it.
05-07-2007 07:56 AM
Hi Manish,
You have to have to configure standby ip address and it is the whole purpose of HSRP which gives a virtual ip address. So once ip address is configured then you have to configure "preempt" keyword basically reinitiates election process.
So you have to configure something like this
standby 1 ip
standby 1 preempt
Check the configuartion section
http://www.cisco.com/univercd/cc/td/doc/cisintwk/ics/cs009.htm#wp3330
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12120ea2/3550scg/swhsrp.htm
HTH
Ankur
*Pls rate all helpfull post
05-07-2007 07:36 AM
Hi Ankur,
Thanks for helping get this idea, although had learnt about this, but never got this idea to implement the same.
05-07-2007 07:57 AM
Hey Sam,
You are always welcome and thanks for appreciating my effort.
Regards,
Ankur
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: