cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
407
Views
10
Helpful
3
Replies

Configuring a SIP to SIP Gateway

jbroderick
Level 5
Level 5

I am trying to configure a SIP to SIP gateway so I can get a SIP trunk through the firewall. Do I use Dial Peers to direct the traffic? The document gives me basics but not specifics.

3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

Yes you use dial-peers voip for both inbound and outbound. Generally speaking, you will have "codec transparent" set on these.

You will need and IP-to-IP image to do that, filename ends in _isv, but you probably knew that already.

Does it helps? please rate post if it does!

No, I didn't know this. I am using a 2821 router running this image: c2800nm-advipservicesk9-mz.124-11.T1.bin. Will this work?

No I don't think it will work. Anyway, another needed piece of configuration is:

voice service voip

allow-connections sip to sip

Then, to see how things are going, "term mon" and "debug ccsip message" when placing a call.

Thank you for the nice rating and good luck!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: