Can I enable 802.11b/g on individual radios instead of globally?

Unanswered Question
May 7th, 2007

I am deploying 400 new APs. There is an existing wireless network. I need to turn up some of the radios before I turn up the rest. Right now I have 802.11b/g network turned off globally across all controllers. What I want to know is can I enable 802.11b/g radios selectively on individual APs or does it have to be done globally across the controller?

Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
shh5455 Mon, 05/07/2007 - 12:32

Thanks, but the Operational Status is still down. (Presumably because I have 802.11b/g disabled globally). Is there a way to override the global setting for individual APs?

ankbhasi Mon, 05/07/2007 - 22:59

Hi Friend,

The only workaround is globally enable for all APs and manually admin down for respective APs for b/g radio. I agree its a tough job when you have 400 APs but if you can run some script it will be a matter of seconds.

And if you have WCS you can use AP template for that purpose which again will take less time than manual work.

Regards,

Ankur

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode