Hi,
We have recently set up a 6509, experiencing errors on both of the
WS-X6748-GE-TX modules. Its on the trunk interfaces to 2 cisco WS-C3550-24.
When we moved the trunk to the sup port
we got no errors.
We are planning to connect a pc to the ports to see if the problem persist.
Any ideas ?
#sh int GigabitEthernet1/3
GigabitEthernet1/3 is down, line protocol is down (notconnect)
Hardware is C6k 1000Mb 802.3, address is 001a.a249.8aaa (bia 001a.a249.8aaa)
MTU 1546 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation ARPA, loopback not set
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is desired
Clock mode is auto
ARP type: ARPA, ARP Timeout 04:00:00
Last input 1d03h, output 1d03h, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/100455/0 (size/max/drops/flushes); Total output drops: 1
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
43209443 packets input, 51556057716 bytes, 0 no buffer
Received 9745 broadcasts (9148 multicast)
0 runts, 0 giants, 0 throttles
100455 input errors, 0 CRC, 0 frame, 64 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
43208415 packets output, 51699821574 bytes, 0 underruns
1 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
Regards,
Bjornarsb