2950 Linked to Net but can't ping

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ankbhasi Tue, 05/08/2007 - 08:33
User Badges:
  • Cisco Employee,

Hi Paul,

When you say you connect your desktop it is effectively off the network? Can you confirm if the link light comes up? Can you confirm what is the ip address you assigned to your 2950 switch?

There are many things to start from. So ca nyou post your "sh run" and "sh vlan" and same for "4006" switch also. Looking at the configs of both the switches lot of things will get clear and easy to start with.



bjornarsb Tue, 05/08/2007 - 08:40
User Badges:
  • Bronze, 100 points or more


I suppose that you have configured trunk between your 2950 and 4006 ?

The mgmt vlan must be the same on both sides and it need to be allowed on the trunk (if you have a filter)

A quess is that you have link, but problems with trunk negotiation.



Amit Singh Wed, 05/09/2007 - 02:52
User Badges:
  • Cisco Employee,


Please paste your switch configurations from both the sides.

-amit singh


This Discussion