Hi,
I am trying the simplest of configurations, attempting to Load-Balance traffic using two servers and a single CSS. I am using "Routed" mode, but am experiencing problems with NAT. I am new to the world of CSSs.
I have two servers that have the VIP 80.80.80.230. All traffic is initiated from the client-side (public) and talks to this VIP address. All RETURN traffic must be NATed (by the CSS) with this VIP address. I would expect:-
CLIENT (PUBLIC) -----> 80.80.80.230 (SERVER-VIP)
CLIENT (PUBLIC) <----- 80.80.80.230 (SERVER-VIP)
However, this configuration does not seem to work for me. When I sniff, I see the return traffic is NOT being NATed ....I see the following :
CLIENT (PUBLIC) ----------------------> 80.80.80.230
CLIENT (PUBLIC) <----------------------10.10.10.2
Here is my config :
ip route 0.0.0.0 0.0.0.0 80.80.80.225 1
!************************* INTERFACE *************************
interface e2
bridge vlan 2
!************************** CIRCUIT **************************
circuit VLAN1
ip address 80.80.80.227 255.255.255.240
circuit VLAN2
ip address 10.10.10.1 255.255.255.0
!************************** SERVICE **************************
service server1
ip address 10.10.10.2
port 5060
active
service server2
ip address 10.10.10.3
port 5060
!*************************** OWNER
owner me
content lbal
port 5060
protocol udp
vip address 80.80.80.230
add service server1
add service server2
application sip
active
!*************************** GROUP
group clients-group
vip address 80.80.80.230
add service server1
add service server2
active
CSS11501 /Version 7.4
I have tried this config with and without the NAT Group (clients-group) but to no avail.
Please please can someone stop me from going crazy with this. Any help really apprectaied.
Grazie !
Matt
