Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
377
Views
2
Helpful
3
Replies

PIX and DSCP values

jmprats
Level 4
Level 4

‎05-10-2007 12:41 AM - edited ‎03-11-2019 03:11 AM

Does the PIX reset the QoS DSCP values in the IP packets through it?

Labels:
0 Helpful
3 Replies 3

cpembleton
Level 4
Level 4

‎05-11-2007 09:05 AM

Only 7.x and up will support QoS. Any version prior to that will drop the TOS flag within the IP header.

Thanks,

Chad

Please rate if this helps!

jmprats
Level 4
Level 4
In response to cpembleton

‎05-14-2007 01:28 AM

I have a 7.x version, and I mark the DSCP value before the packet enter into the pix and when the packet goes out the DSCP values is 0

0 Helpful

cpembleton
Level 4
Level 4
In response to jmprats

‎05-14-2007 04:24 AM

Did you configure a QoS policy? QoS is not just turned on.

7.2 QoS Policy:

http://www.cisco.com/en/US/customer/products/ps6120/products_configuration_guide_chapter09186a008063705d.html

Thanks,

Chad

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card