PRI / SRST incoming calls get dial tone

Unanswered Question
May 10th, 2007
User Badges:

I am running CCM 4.1.3 with SRST. In fallback mode, when calling INTO the PRI, I get a secondary dial tone. If I then dial an extension, it will ring the phone. What am I missing to allow a normal call from the outside to reach the intended DID? Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Brandon Buffin Thu, 05/10/2007 - 05:06
User Badges:
  • Purple, 4500 points or more

Under your incoming dial peer, you need the command "direct-inward-dial".

Hope this helps. If so, please rate the post.


hauchinango Thu, 05/10/2007 - 05:14
User Badges:


I have the following dial peer and problem persists:

dial-peer voice 7777 pots

preference 1

destination-pattern 9T

progress_ind setup enable 3

incoming called-number .

fax rate disable


astinus Thu, 05/10/2007 - 05:16
User Badges:
  • Bronze, 100 points or more

Believe you need to indicate the port under here as well. IE if 1/0 is your PRI, you need the command

port 1/0:23

under this dial peer.

Hope this helps.


hauchinango Thu, 05/10/2007 - 05:54
User Badges:


Yes, I omited the port. I put the port in and also an num-exp statement, and incoming works. Thansk to all

Brandon Buffin Thu, 05/10/2007 - 05:17
User Badges:
  • Purple, 4500 points or more

If you do "debug voip dialpeer" and make an incoming call, do you see that the call hits the proper dial peer?



This Discussion