cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
221
Views
0
Helpful
1
Replies

MGCP problem with FXS ports

mike.fitzgerald
Level 1
Level 1

CM 4.2

2811 12.4(11)T

i am having problems with mgcp binding onto various fxs ports 2 different routers. no config changes on either and when i do a "sh mgcp endpoints" it recognizes some fxs's , but not all fxs configured. i have bounced both routers to no avail......any insight is appreciated.

1 Reply 1

Check if the FXS ports on a "show ver" match the number of module ports you have. The the FXS VICs identical? Last time I saw something like this someone was using VIC2-2FXS (version 2) instead of a VIC-2FXS in an NM-2V.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: