POE and Cisco Phones

Answered Question
May 10th, 2007
User Badges:

Hi,


I would have a Cisco Installation with a Linksys Switch SRW224P 24 puertos PoE.


As far as I known, Cisco 7911 and 7941 are compatible with that switch, but I am afraid of the swith not having enough power for all 24 ports...


Power feeding of Ethernet is provided on the 10/100 Base-T ports with maximum output power per port of up to 15.4W simultaneously on 12 ports. Alternatively, the switch can power all ports at a maximum of 7.5 W per port.


So, it can power either 24 ports or only 12 ports (half) depending on phone voltage requirements...


Question: Would ALL my Cisco phones work on all the ports of the swith ?


thks


Correct Answer by Rob Huffman about 10 years 2 months ago

Hi Andres,


You should be fine for power as both the 7911 and 7941 are Class 2 devices. Have a look;


The 7940G/7941G and 7960G/7961G are class 2 devices (7.7 watts) and the 7941G-GE/7961G-GE phones are class 3 devices (15.4 watts).These are not configurable settings.


Have a look;


7910/7940/7960 Power requirements;


http://www.cisco.com/en/US/products/hw/switches/ps708/products_installation_guide_chapter09186a008020e088.html#wp1008467



The Cisco IP Phone 7911G supports both Cisco inline power and IEEE PoE (Class 2).


From this doc;


http://www.cisco.com/en/US/products/hw/phones/ps379/products_qanda_item0900aecd8039de5e.shtml


Hope this helps!

Rob

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Rob Huffman Thu, 05/10/2007 - 14:53
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Andres,


You should be fine for power as both the 7911 and 7941 are Class 2 devices. Have a look;


The 7940G/7941G and 7960G/7961G are class 2 devices (7.7 watts) and the 7941G-GE/7961G-GE phones are class 3 devices (15.4 watts).These are not configurable settings.


Have a look;


7910/7940/7960 Power requirements;


http://www.cisco.com/en/US/products/hw/switches/ps708/products_installation_guide_chapter09186a008020e088.html#wp1008467



The Cisco IP Phone 7911G supports both Cisco inline power and IEEE PoE (Class 2).


From this doc;


http://www.cisco.com/en/US/products/hw/phones/ps379/products_qanda_item0900aecd8039de5e.shtml


Hope this helps!

Rob

Actions

This Discussion