ASA NAT problem... help me.

Unanswered Question
May 10th, 2007

why not nat translation ... i don't understand.. please help me

==== config ====

nat (inside1) 1 10.10.10.0 255.255.255.0

nat (inside2) 1 10.10.11.0 255.255.255.0

global (outside) 1 192.168.1.1-192.168.1.100

some PC not connect to outside network

error message :

portmap translation creation failed

asa or pix bug?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sebastan_bach Fri, 05/11/2007 - 02:48

for the number of nat sources ur pool is very small here u can configured dynamic nat. configure pat by specifying a single ip address.

u can also specify the a single ip address after the gobal pool u have specified.

so once the pool is full then the pix will pat the translations on that single ip.

hope this helps

regards

sebastan

vitripat Fri, 05/11/2007 - 02:54

Here's what you need-

global (outside) 1 interface

As pointed out by Sebastan, your global pool seems too small to support both inside networks and hence we need to PAT using the above command. Hope that helps.

Regards,

Vibhor.

Actions

This Discussion