WAE link redundancy

Unanswered Question
May 11th, 2007
User Badges:

Hi Sir,


I have one unit Cisco WAE-612 to be deployed at a data center, which consists of two core/distribution switches. I'm configuring WCCPv2 to intercept traffic for optimization.


The WAE-612 has two 10/100/1000BASE-T interfaces. At first, I'm planning to connect only one GE interface to one of the distribution switches on a single VLAN.


If link redundancy is required using both GE interfaces, how do I connect the WAE now? Each GE goes to one of the core/dist. switches? WCCP run on two subnets?


Please advise.



Thank you.


B.Rgds,

Lim TS


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
carenas123 Thu, 05/17/2007 - 06:51
User Badges:
  • Silver, 250 points or more

They are in seperate networks.Cisco WAE devices can be transparently deployed in-line using an optional 4-port network interface card with the ability to fail-to-wire in the event of a software or hardware failure, preserving traffic flow in both directions and ensuring no loss of network connectivity. Refer URL

http://cisco.com/en/US/products/ps6474/products_data_sheet0900aecd80329e39.html

limtohsoon Thu, 05/17/2007 - 08:22
User Badges:

Hi Carlos,


In my data center scenario, how can I utilize both the GE interfaces on the WAE?


Do you typically recommend in-line deployment over interception deployment?



Thank you.


B.Rgds,

Lim TS


Actions

This Discussion