Annoying Issue with DMVPN tunnel connections

Unanswered Question

Good morning. I have been suffering through an issue with our DMVPN tunnels for the last year or more and finally decided to try and get some help.


The issue is if a tunnel goes down it does not always recreate itself automatically. I need to telnet to the routers serial interface and do the following command on the tunnel interface. "no tunnel key 10000" then I put the tunnel key back in and the tunnel gets created.


I am looking at rolling this out across many different sites if I can solve this issue.


Hardware at the remote sites are 1711 router with IOS 12.3(7)XR6 and the headend router is a 3825 with IOS 12.3(11)T9.


The remote site is working with a static ip asigned to its outside ethernet interface.


Thanks for all the help.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Danilo Dy Fri, 05/11/2007 - 07:05
User Badges:
  • Blue, 1500 points or more

Hi,


Thus your configuration have more than one tunnel interface using the same tunnel source address?


Dandy

Actions

This Discussion