bridging serial link to ethernet

Unanswered Question
May 11th, 2007
User Badges:

Hi all, If I have a leased line connection presented on a 2 meg serial connection on my router, would it be possible to bridge between them, would I have to configure the router as a bridge either end, is this possible ?


cheers


Carl

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pciaccio Mon, 05/14/2007 - 04:47
User Badges:
  • Silver, 250 points or more

You can set up your router as a bridge. enable no ip routing on your router. The serial link set for bridge group 1 and add the same command to the ethernet interface. Add bridge group 1 protocol ieee (global command). This will enable the router to be a bridge and will bridge the traffic from the ethernet to the serial link....Good Luck...

Actions

This Discussion