3750 Switch Stack - Remove member from stack

Answered Question
May 14th, 2007

Hello,

I'm new to using the 3750 switches and am trying to understand all of the necessary steps to completely remove a member from the stack. The current stack only consists of two switches and I need to remove one (which happens to be the slave)... leaving the other to run solo permanently.

From what I understand, the steps would go like this...

1.) Remove power from switch to be removed

2.) Issue command "no switch 2 provision ws-c3750-48p"

3.) Issue command "copy run start"

Done.

I would expect this to enable me to remove the switch and also removes all reference to the removed switch from the config.

Did I miss anything here?

Thanks!

-Adam

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
a.veschak Mon, 05/21/2007 - 11:03

Phillip,

Thanks for the reply.

I've seen the link you provided before... I just wanted to make sure I wasn't missing anything... seemed a little to simple, but I guess that's all there is!

Regards,

-Adam

Actions

This Discussion