IP HSRP as tunnel destination

Unanswered Question
May 14th, 2007

Hi,

is it possible to use HSRP address as GRE tunnel endpoint in order to have redundancy?

Regards

Stefano

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Mon, 05/14/2007 - 09:40

Hmm no, what sense it would make? Use a loopback address if you have multiple interfaces connecting to the other end of the tunnel.

s-durando Mon, 05/14/2007 - 22:34

I have one router at remote site and two routers at headquarter site with HSRP configured between them. If I want to configure only one tunnel interface at remote site, can I use headquarter's HSRP address as tunnel destination?

Paolo Bevilacqua Tue, 05/15/2007 - 03:18

No, you will need to configure two tunnels, one per router. The end result will be the same.

minumathur Mon, 05/14/2007 - 21:56

Hi

i think it is not possible ,because i check command line in router, but nothing i can found out similar to that.

-Minu

Actions

This Discussion