No Route Warnings

Unanswered Question

In our syslog we are getting a ton of the following messages: No route to from Now is a static nat on our outside interface and the 70. address is some IP unaffiliated with us. Unles I'm reading the message wrong, why would we be getting a message saying no route to when that is on my interface and is it the 70 address sending an ICMP message to us stating such?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
vitripat Wed, 05/16/2007 - 06:22

Can you provide output from "show static" and "show route"? If using 7.x commands would be "sh run static" & "sh run route".



acomiskey Wed, 05/16/2007 - 12:10

I receive these "no route to" messages as well. Doesn't seem to effect anything.

No route to 75.x.x.x from 208.x.x.x

208.x.x.x = my asa outside interface

75.x.x.x = a public ip of a remote access vpn client

Could also have been a vpn client in your case? I think if that were the case we would be onto something here.


This Discussion