Rob Huffman Tue, 05/15/2007 - 04:27
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications


The 350 is not going to work due to the required IOS needed to function with the WLC Have a look;

Workgroup bridge (WGB) support - Cisco Aironet autonomous access points operating in WGB mode can now associate to Cisco Aironet lightweight access points (except Cisco Airespace AP1000 series access points) to provide an 802.11 wireless connection to wired devices. The WGB is supported only in client mode and not in infrastructure mode and must run Cisco IOS Release 12.4(3g)JA or later (on 32-MB access points) or Cisco IOS Release 12.3(8)JEB or later (on 16-MB access points). WGB functionality is not supported for use with hybrid REAP.

The autonomous WGB access point learns the MAC address of the wired client and then informs the lightweight access point and controller that the device is operating on the wireless network. This scenario provides transparent bridging for wired clients and secure roaming.

From these release notes;

Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(8)JEB


April 26, 2007

These release notes describe minor features and caveats for Cisco IOS Maintenance Release 12.3(8)JEB. They also provide important information about Cisco Aironet 1100, 1200, and 1230 series autonomous access points. The Cisco Aironet 350 series is no longer supported in this release or any future release.

Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.4(3g)JA


April 26, 2007

These release notes describe features, enhancements, and caveats for special technology early deployment release Cisco IOS Release 12.4(3g)JA. Release 12.4(3g)JA supports 32 Mb Cisco autonomous access points including Cisco Aironet 1100, 1130, and 1240 series access points, 1300 series access point/bridges, and 1400 series bridges.

Hope this helps!



This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode