V WIC 1MFT G703 E1 CONTROLLER CARD

Answered Question
May 14th, 2007
User Badges:

HI,

V WIC 1MFT G703 E1 CONTROLLER CARD,It will support 2mbps data in 1841 cisco?

KIndly confirm the config:

Config t

Controller E1 0/0/0

channel-group 0 unframed

Config t

int serial 0/0/0:0

bandwidth 2048

ip address x.x.x.x x.x.x.x

Kindly revert back

Correct Answer by paolo bevilacqua about 9 years 11 months ago

Another note, if you use "timeslots 1-31", you don't need the G.703 version of VWIC, but just the normal one, that is much less expensive.

The G.703 version is only needed when you absolutely need to support "unframed".

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
jaffer_sathik2010 Mon, 05/14/2007 - 20:53
User Badges:

Hi,


Since channel-group is set to 'unframed',It will definitely support 2 mbps speed.


Please rate ,if it is useful.


--Jaffer

CSCO10320953 Mon, 05/14/2007 - 21:11
User Badges:

HI,


VWIC IMFT G703 EI CONTROLLER CARD ,IT WILL SUPPORT DATA?

minumathur Mon, 05/14/2007 - 22:14
User Badges:
  • Bronze, 100 points or more

Hi


I think you need to use timeslot 1-31 ,please see below command .


channel-group 0 timeslots 1-31


I hope this will help you out.


-Minu


paolo bevilacqua Tue, 05/15/2007 - 03:21
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

There is a difference,


Channel-group 1 timeslots 1-31 is framed at 1.984 Mbps.


Channel-group 1 unframed, is 2.048 Mbps.


On an unframed circuit you can use both.


Of course all the vwic cards supports data.

Correct Answer
paolo bevilacqua Tue, 05/15/2007 - 04:04
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Another note, if you use "timeslots 1-31", you don't need the G.703 version of VWIC, but just the normal one, that is much less expensive.

The G.703 version is only needed when you absolutely need to support "unframed".

Actions

This Discussion