Solved: V WIC 1MFT G703 E1 CONTROLLER CARD

CSCO10320953 · ‎05-14-2007

HI,

V WIC 1MFT G703 E1 CONTROLLER CARD,It will support 2mbps data in 1841 cisco?

KIndly confirm the config:

Config t

Controller E1 0/0/0

channel-group 0 unframed

Config t

int serial 0/0/0:0

bandwidth 2048

ip address x.x.x.x x.x.x.x

Kindly revert back

paolo bevilacqua · ‎05-15-2007

Another note, if you use "timeslots 1-31", you don't need the G.703 version of VWIC, but just the normal one, that is much less expensive.

The G.703 version is only needed when you absolutely need to support "unframed".

jaffer_sathik2010 · ‎05-14-2007

Hi,

Since channel-group is set to 'unframed',It will definitely support 2 mbps speed.

Please rate ,if it is useful.

--Jaffer

CSCO10320953 · ‎05-14-2007

HI,

VWIC IMFT G703 EI CONTROLLER CARD ,IT WILL SUPPORT DATA?

minumathur · ‎05-14-2007

Hi

I think you need to use timeslot 1-31 ,please see below command .

channel-group 0 timeslots 1-31

I hope this will help you out.

-Minu

paolo bevilacqua · ‎05-15-2007

There is a difference,

Channel-group 1 timeslots 1-31 is framed at 1.984 Mbps.

Channel-group 1 unframed, is 2.048 Mbps.

On an unframed circuit you can use both.

Of course all the vwic cards supports data.

paolo bevilacqua · ‎05-15-2007

Another note, if you use "timeslots 1-31", you don't need the G.703 version of VWIC, but just the normal one, that is much less expensive.

The G.703 version is only needed when you absolutely need to support "unframed".