PIX Stateful VPN Failover

Unanswered Question
May 15th, 2007

Hi!

I just installed a PIX Failover.

Failover is working except w/ VPN. VPN client can connect to the active PIX device whether Primary or Secondary is the active one. Problem is when a Failover occurs and a VPN client is connected, the traffic is not passed through. I had to reconnect the VPN Client.

I was under the impression that VPN Stateful failover will enable the VPN client to continue working even when a Failover occurs.

I'm running PIX v 7.2(2) on both PIX.

PIX UR license on Primary

PIX FO license on Secondary

FO link & Stateful failover link shares the same port - eth 0.

question - is there an additional command to enable VPN stateful failover.

i followed this link as a guide to configure the FO

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

Thanks!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Fri, 12/07/2007 - 09:03

Actions

This Discussion