cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1782
Views
0
Helpful
2
Replies

cisco aironet 1100 web interface?

Hello everyone, we use a Cisco Aironet wireless access point here for wireless internet access, I wanted to know what the default web interface address usually is and what the user/pass would be, thanks

2 Replies 2

Rob Huffman
Hall of Fame
Hall of Fame

Hi Sharad,

Here is the required info;

Default IP Address Behavior

Recent Cisco IOS releases have changed the way an unconfigured access point behaves when booted for the first time. This section describes this behavior and provides instructions on how to open the access point's configuration pages.

Cisco IOS Release 12.2(15)JA and Earlier

Login/Password

Cisco/Cisco

Case-sensitive.

SSID

tsunami

Radio status

Enabled

IP Address

Assigned by DHCP

If DHCP disabled, the default IP address is 10.0.0.1.

----------------------------------------------------------------------------

Cisco IOS Release 12.3(2)JA

Login/Password

Cisco/Cisco

Case-sensitive.

SSID

tsunami

Case-sensitive.

Radio status

Enabled

IP Address

Assigned by DHCP

If DHCP disabled, the default IP address is 10.0.0.1.

-----------------------------------------------------------------------------

Cisco IOS Release 12.3(4)JA and Later

Login/Password

Cisco/Cisco

Case-sensitive.

SSID

None assigned

You must create an SSID. See the "Configuring Security Settings" section for additional information.

Radio status

disabled

You must enable the radio interfaces. See the "Enabling the Radio Interfaces" section for additional information.

IP Address

Assigned by DHCP

If DHCP disabled, the access makes several attempts to get an IP address from a DHCP server. If it does not receive an address, it assigns itself an IP address of 10.0.0.1 for 5 minutes and becomes a mini-DHCP server. During this 5 minute window, you can browse to the default IP address and configure a static address. If after 5 minutes the access point is not reconfigured, it discards the IP address and sends DHCP request indefinitely.

--------------------------------------------------------------------------------

Note: If you miss the five-minute window for browsing to the access point at 10.0.0.1, you can power-cycle the access point to repeat the process.

From this good doc;

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_quick_start09186a008027dfe5.html#wp27797

Hope this helps!

Rob

jaichauh
Level 1
Level 1

Hi there!

Default IP address is 10.0.0.1 for five minutes. During that five minutes, you can browse to that IP address to configure the unit. If after five minutes the unit has not been reconfigured, it discards the 10.0.0.1 address and reverts to requesting an address from the DHCP server. If it does not receive an address, it sends requests indefinitely. If you miss the five-minute window for browsing to the access point at 10.0.0.1, you can power-cycle the access point to repeat the process.

Default usrename/passowrd = Cisco/Cisco (Capital C)

For reference:

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_guide_chapter09186a0080606cbe.html

Regards,

-Jai

JC
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: