cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
298
Views
0
Helpful
1
Replies

FWSM Module Active/Standby configuration

Hi all,

I have 3 FWSM modules that I am going to install on 3 different 6509, I am configuring the 3 FW modules in transparent mode with two context in each FWMS module.

Do you know if it is possible to configure the following:

- FWSM A has context 1 active and context 2 active

- FWSM B has context 1 in standby (backup of context 1 in FWSM A)

- FWSM c has context 2 in standby (Backup of context 2 in FWSM A)

The 3 FWSM modules are installed on different switches.

Regards

1 Reply 1

Jon Marshall
Hall of Fame
Hall of Fame

Hi Vicente

To my knowledge you cannot have more than 2 FWSM's in an active/standby scenario.

I believe the problems would come when you come to configure failover on the active unit and try to specify 2 different standy units.

HTH

Jon

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: