Port redirection Pix 501

Unanswered Question
May 15th, 2007

I have a pix 501 and am needing to do some port forwarding. I have a DVR (being used for security cameras) it has an internal IP address of I need to have port forwarding setup for 3000 - 3007 and 8800

Is it possible to do this through teh pdm or do I need to do it at command line? I'm at a loss.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
acomiskey Tue, 05/15/2007 - 12:32

Never did it via PDM sorry.

static (inside,outside) tcp interface 3000 3000 netmask

static (inside,outside) tcp interface 3007 3007 netmask

static (inside,outside) tcp interface 8800 8800 netmask

I am assuming you are using outside interface of pix and ports are tcp. Don't forget to allow in your acl as well.


This Discussion